Menu
  • Home
  • Another round of solve that 2002 Ford ZX2 Problem…..

Another round of solve that 2002 Ford ZX2 Problem…..

#443670
nsman06nsman06
Participant

    Okay so this for all the ZX2 folks out there. First off this is my first time doing a clutch job and let me tell you it is thoroughly kicking my butt! The transmission is next to impossible to drop with both CV axles in it. Even with the drivers side installed it is still very hard to drop it. So word to the wise take both CVs out before dropping the trans. Also the bolts are tight. I had a few that wouldnt come off with an impact wrench. Also another note is that the passenger side CV is actually 2 parts and it is very hard to separate them. So take that whole thing out as a unit if you are going to do the CVs. Also another note worthy of making is that the lower ball joints if they are original will SPLIT on you. However all is not lossed go to Napa and buy a 3/4inch boot and that will cover them. Just make sure to pack them full of grease. Umm so, so far that is the most advice I can give you. Oh and one last thing as usual parts are hard to get for these cars so anticipate around a week for the parts to show up depending on where you are vs where the parts are.

    So ill update this one more time once the car is driveable.
    -Nick

    Loading…
    slot gacor https://ibufoundation.or.id/totoup/ situs togel situs togel togel online bo togel situs togel situs togel toto macau agen toto situs togel situs toto bo togel situs togel situs togel resmi situs togel situs toto situs togel situs togel situs togel situs toto togel online situs toto rimbatoto rimbatoto rimbatoto situs toto bo toto situs toto situs togel situs toto slot gacor situs toto https://fbik.unissula.ac.id/bandar/ situs toto slot gacor https://tp.fkip.ulm.ac.id/toto/ slot gacor slot gacor toto slot slot gacor bo togel situs toto situs togel situs togel slot demo slot gacor slot gacor