Menu
  • Home
  • any tips on ball joints and tie rod ends?

any tips on ball joints and tie rod ends?

#443726
Bad_dudeBad_dude
Participant

    Hey,
    If you have a Harbor Freight near, I have some links below for you. I have replaced all of the boots on my ball joints, upper, tie rods. I did not do it for the lowers as they look fat and new. I periodically squeeze them to see if it’s torn or grease come out of a tear that I cannot see.
    I used the pitman puller and it takes the joints off in a few seconds.

    http://www.harborfreight.com/tie-rod-an … -1752.html
    http://www.harborfreight.com/3-4-quarte … 99849.html
    http://www.harborfreight.com/inner-tie- … 96558.html

    Hey Eric,
    When ever possible, could you do videos on how to replace upper arm bushings and rear control arm boots and bushings change?
    I like to do preventive maintenance rather than replacing parts.
    Thanks.

    Loading…
    slot gacor https://ibufoundation.or.id/totoup/ situs togel situs togel togel online bo togel situs togel situs togel toto macau agen toto situs togel situs toto bo togel situs togel situs togel resmi situs togel situs toto situs togel situs togel situs togel situs toto togel online situs toto rimbatoto rimbatoto rimbatoto situs toto bo toto situs toto situs togel situs toto slot gacor situs toto https://fbik.unissula.ac.id/bandar/ situs toto slot gacor https://tp.fkip.ulm.ac.id/toto/ slot gacor slot gacor