This topic contains 1 reply, has 2 voices, and was last updated by 
Richard Kirshy 2 years, 4 months ago.
-
Topic
-
Hi,
I have a lowered Pontiac G8 and my ball joints is loose so I need to replace the control arm.
I’m trying to figure out how can I tighten the control arm bolt with the car on the ground. Since its lowered I won’t be able to get in there. I was thinking I could use a ramp to get the car high enough but moving the car with loose control arms may not be good. I would love some suggestion.
Many Thanks
Viewing 1 replies (of 1 total)
-
Replies
-
If you drive the vehicle up onto the ramps slowly you should have no issues.
Remember you’ll still need to get a front end alignment when completed.
Viewing 1 replies (of 1 total)
You must be logged in to reply to this topic.
