I’m attempting to align the front subframe . It was recently removed . Again it is a 2005 Honda Civic Dx 4 door, 5 speed, there are two alignment holes on the sub frame , one on the left side and one on the right at each corner. The holes are close to the bolts that fasten subframe to body/chassis and are at the back of the subframe near the torsion bar side. These holes align with holes on the body. Apparently special alignment pins are used to pass through the subframe holes to the body holes before all four bolts are torqued . SO …. do I need these alignment pins and where would I find them ?
You must be logged in to reply to this topic.