Menu

2006 Silverado Ignition Issue

Home Forums Stay Dirty Lounge Service and Repair Questions Answered Here 2006 Silverado Ignition Issue

This topic contains 1 reply, has 2 voices, and was last updated by Nightflyr * Richard Kirshy 5 months, 3 weeks ago.

  • Creator
    Topic
  • #953834
    Jim W
    Jim Williamson
    Participant

    A few weeks ago, I went to start my 2006 Silverado – starter turned but engine never fired. I eventually got figured out it was a spark issue. I replaced the distributor cap & rotor, ignition coil, and crankshaft position sensor – still no start. I noticed a bad 15A fuse (INJ2) and replaced it – still no start. I replaced the ignition control module and it started right up.

    Here’s where the problem continues…the truck ran great for a week, then all of the sudden it died out on my in the middle of driving. I got it towed back home and tried swapping out the ignition control module again – Didn’t solve the issue this time.

    Any ideas on what I should try next?

Viewing 1 replies (of 1 total)
  • Author
    Replies
  • #953844
    Nightflyr *
    Richard Kirshy
    Participant

    Might first try scanning for any codes and correct any issue(s) that caused them.
    You state it is a no spark condition, start with a wiring diagram of the ignition system.
    A scope would be very helpful.

Viewing 1 replies (of 1 total)

You must be logged in to reply to this topic.

Loading…