2011 Crown Vic code problems

Home Forums Stay Dirty Lounge Service and Repair Questions Answered Here 2011 Crown Vic code problems

This topic contains 1 reply, has 2 voices, and was last updated by Nightflyr * Richard Kirshy 2 years, 10 months ago.

  • Creator
  • #988609
    Trace Tega
    Trace Tega

    Hello, I own a 2011 Crown Victoria. Multiple codes have popped up on my OBDII scanner that I am not sure about. I have check all of my fuses and they are operational, the car runs and starts but dies randomly and sometimes will not start. Rough idle at 1500 – 2000 rpms. Often when started rpms shoot up to 2000 and cars dies.

    the codes are as follows: PO108 Manifold absolute pressure, PO183 Fuel temp sensor A circuit high, PO193 fuel rail pressure sensor A Circuit High, PO354 Ignition Coil D Primary / Secondary Circuit, PO340 Camshaft Position Sensor A Circuit Bank 1 or Single Sensor. I don’t think the car would be operational if all those codes are true I assume it is an electrical problem but don’t know where to start except with checking fuses.

    Thank you – from Vivky_Sticky

Viewing 1 replies (of 1 total)
Viewing 1 replies (of 1 total)

You must be logged in to reply to this topic.