This topic contains 0 replies, has 1 voice, and was last updated by 
Brad Steinagel 3 years ago.
-
Topic
-
Apologies if this has been covered in the forum before. I can’t find a search function for the forum. I’m reading through the engine mount tightening procedure in the service manual and I’m not sure if I’m understanding it correctly. After twenty minutes of reading and re-reading, it sounds like the mounts need to be tightened in the following sequence:
1. Side Engine Mount
2. Trans Mount
3. Lower Torque Rod
4. Upper Torque RodMy question is: if replacing just the side engine mount, do I still have to loosen the other mount and both torque rods before tightening the side engine mount? Or does this procedure only apply when installing the entire engine/trans assembly in the vehicle?
You must be logged in to reply to this topic.
