This topic contains 3 replies, has 2 voices, and was last updated by Matt Brandsema 6 days, 14 hours ago.
So I was all set on rebuilding a transmission from a Saturn when at the last second the guy sells the car before I can buy it. I even bought the rebuild manual! I was set on doing another rebuild video series so I got my hands on a 4L60E transmission out of a 1995 Chevy truck (4WD). This transmission is the same as the 700R4. The best thing is, I didn’t even have to buy another manual, it uses the same manual as my 3T40 tranny rebuild!
This time around I slowed things down and did a voice over explaining each step. The only exception is Part 1, where I put some background music in (Crappy music.. I used YouTubes music so I wouldn’t have any copyright claims).
I only had to buy one special tool for about 70 bucks on ebay. The procedures and measurements from the factory service manual were all followed to the letter. All clearances were checked and within specs. The only measurement not on camera is the input shaft end play.
Here it is! 11 videos, totaling about 2 hours in length.
PART 1: VALVEBODY AND PUMP REMOVAL
PART 2: GEAR TRAIN REMOVAL AND INSPECTION
PART 3: VALVEBODY AND PUMP DISASSEMBLY
PART 4: PUMP / VALVEBODY SERVICE AND CASE COMPONENTS REMOVAL
PART 5: PAINTING AND SEALS REPLACEMENT
PART 6: REVERSE INPUT DRUM AND INPUT CLUTCH ASSEMBLE
PART 7: INPUT DRUM ASSEMBLY AND SOME BUSHINGS REPLACEMENT
PART 8: BUSHINGS AND SEALING RINGS REPLACEMENT
PART 9: FINAL TOUCHES BEFORE REASSEMBLY
PART 10: REASSEMBLY OF PUMP AND GEAR TRAIN
PART 11: FINISHING REASSEMBLY
You must be logged in to reply to this topic.