- This topic has 3 replies, 4 voices, and was last updated 12 years, 10 months ago by
.
-
Topic
-
-
Replies
-
Welcome to the forums,
I would recommend posting this question in the “Service and Repair” section as this is the”How To…” area C8-)
Quoted From BTmac:
Hello all.
I did a head job on my 87 Accord and after re-assembly It is misfiring, and I can’t get the timing right. Supposed to be 24 Degrees Before TDC .
The distributor will not rotate far enough to get it there . Is my distributor bad, or is the timing between the crankshaft and
cam off? . (the distributor is rotated directly by the camshaft and i did pull and plug the vacuum lines from the vacuum advance before using the timing light)
I’m not sure if the engine would even run with the timing off by 1 or 2 teeth.
and advice would be appreciated.I would first verify that the cam and crank timing marks are lined up properly ( sounds like they might be off )
I take it this is the A20A3 engine.
I had a 1987 accord SI i will try to find the service manual for you.
Man i am good, found it in an old backup.
http://www.megaupload.com/?d=5NN4Q1IE
- You must be logged in to reply to this topic.