This topic contains 0 replies, has 1 voice, and was last updated by 
lothian 1 year, 5 months ago.
-
Topic
-
2006 Hyundai Azera Limited
I’m n the midst of replacing bushings in both lower control arms The Hyundai Azera LCA has three different size bushings pressed in. I managed to replace two bushings using a bushing press kit. But the third simply will not budge… at all.
I stop wrenching when I can lift my 200lb buddy (who serves as as dead weight bearing down on the lower control arm) off the ground. It’s as if the bushing is welded into bore! A shop press is the correct tool for this job, and I do not own a shop press.
Anyone with experience successfully removing diabolically stuck bushings care to offer some ideas I should try?
You must be logged in to reply to this topic.
