This topic contains 0 replies, has 1 voice, and was last updated by 
Charles DiGi 1 year, 9 months ago.
-
Topic
-
I have a 97 Acura cl 2.2 vtec (F22B1 engine) I broke timeing belt and had to replace all exhaust valves.i also deleted the balance shafts.so I got it all back together and the motor back in the car an went to start it and it sounds like it wants to start even acts like it but will not run.when the timeing belt broke it ripped the sensor off the oil pump.so I thought a wire broke sumwere.i check for continuity on the plug from sensor to pcm blue and green wires I get 19.51 the red and white wires I get 0.4.the sender tested 22.22 on blue and green wires red and white wires I got 0.i went to the junk yard and got a Honda sensor off the same car and motor set up.i installed it cleaned the code from the pcm.tryed to start it and no go and I got the same code.thw pcm was fine when the timeing belt broke so I guess it’s ok I not sure how to test it iv bin working on this for 3 months and I’m about out of ideas I need help!! Plez.
You must be logged in to reply to this topic.
