Menu

D16Y8 timing marks

This topic contains 0 replies, has 1 voice, and was last updated by John Swyers John Swyers 3 months, 1 week ago.

  • Creator
    Topic
  • #963016
    John Swyers
    John Swyers
    Participant

    I am changing the head gasket. I aligned the crankshaft pulley up to the TDC mark and noticed that 1 and 4 were not at TDC. they are about 15 degrees off. Is this normal? If I use the mark, then the motor appears to be advanced by 15 degrees. I know that the crank pulley is on correctly and the car ran a week ago. I just don’t want to bend a valve.

You must be logged in to reply to this topic.

Loading…