This topic contains 3 replies, has 2 voices, and was last updated by 
Richard Kirshy 2 years, 4 months ago.
-
Topic
-
HI PLS HELP HOW TO FIX NOT WORKING HIGH BEAM LIGHT INDICATOR IN THE CLUSTER. IS THERE AN EASY OR TEMPORARY FIX LIKE THOSE VIDEOS THAT USING PIN FROM THE CONNECTOR TO MAKE IT WORK? I TRIED TO CHANGE FUSES AND INSTRUMENT CLUSTER BUT STILL THE SAME.. NO BLUE ILLUMINATION. I AM PLANNING TO WIRE TEMPORARY SMALL BLUE LED LIGHT AND CONNECT TO THE LIGHT SWITCH ITSELF SO THAT IF I DO FLASH OR.HIGH BEAM IT WILL ACTIVATE THE BLUE LIGHT AS AN INDICATOR, BUT DONT KNOW HOW. PLS ANYONE KINDLY HELP ME. THANKS.
-
Replies
-
Did you check to see if the bulb is good?
High the LED bulb in the cluster is good.
If the bulb is good, then you’ll need to check that it is getting the command to turn on when the high beam switch is triggered.
You’ll need a wiring diagram of that circuit.
Could be a bad solder joint, wiring issue, module issue (if so equipped) or switch
You must be logged in to reply to this topic.
