Input shaft bearing noise

This topic contains 2 replies, has 3 voices, and was last updated by Billy Andrews Billy 2 years, 7 months ago.

  • Creator
  • #986861

    I’ve been having some noise from my transmission for a while. Just recently it’s been getting worse. I believe it to be the input shaft bearing on my manual trans but I don’t have the money right now to replace or repair it. It’s a 2006 mustang 4.0l Does anyone know if this is a common issue on those model mustang? Or if there’s any quick fix to hold over untill I can get it replaced. I have already done the clutch and throw out bearing replacement recently. Any recommendations greatly appreciated.

Viewing 2 replies - 1 through 2 (of 2 total)
  • Author
  • #986875
    Nightflyr *
    Richard Kirshy

    Stating the obvious …
    Unfortunately if it is a bad bearing.
    Only fix would be R&R
    Attempting any quick fix would most likely result in dropping the transmission.

    Billy Andrews

    A top-quality fluid like Amsoil Severe Gear or Redline can sometimes work wonders on failing syncros, I’ve seen a miracle or two. I wouldn’t be optimistic about an input shaft bearing, but it might be worth a shot.

Viewing 2 replies - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.