- This topic has 0 replies, 1 voice, and was last updated 4 years, 7 months ago by .
-
Topic
-
First time posting here please excuse me if I’m in the wrong forum.
I removed the front bearing from the spindle and race from the hub. I was going to replace the hub and bearing but the hub was going to take a week to arrive, so I just decided to replace the bearing. My issue is, I pressed in the new bearing into the spindle, up to the snap ring where the original Bearing was seated, then pressed the hub into the newly seated bearing. Now when I went to re install the hub/spindle assembly the bottom a arm is seated, the axle splines line up and seat, but the McPherson struts top bolt hole is a 1/2 inch off from alignment. And nothing I do, (realigning the spindle, etc) will align the bolt. Can I have pressed the bearing in wrong?
- You must be logged in to reply to this topic.