2000 Acura Integra Smackdown!
This video covers the timing belt, water pump, thermostat, valve adjustment, oil pan gasket, cam seals, crank seal, power steering fluid replacement, AFT replacement, tune up, valve cover gaskets, distributor service, distributor ‘o’ ring, drive belts, and a washer hose repair on a 2000 Acura Integra LS with a B18C1 engine.
In addition to this information there are tons of tips, tricks, and some automotive trivia for you to take in.
Thank you for watching!
Become a Premium Member of EricTheCarGuy.com
The best place for answers to your automotive questions
Other Info
Parts I Used (some are affiliate links)
Timing Belt: 114400-P7J-004
Water Pump: 19200-P75-003
Head Cover Set: 12030-PR4-000
PCV Valve: 17130-PK1-003
Thermostat: 19301-P08-316
Distributor Cap: 30102-P54-006
Rotor: 30103-P08-003
Cam Seal (x2): 91203-PFB-013
Crank Seal: 91212-PR3-003
Spark Plug (x4): 98079-5514N
Power Steering Belt: 56992-P72-505 or 4PK850?
Distributor ‘o’ ring: 30110-PA1-732
Fuel Cap: 17670-SM4-A04
Cam Plug: 12513-P72-003
Dipstick (auto trans): 25610-P4R-A01
AC Idler Bearings
Oil Pan Gasket
AC Belt
Alternator Belt
Ignition Wires
Honda ATF
Honda Power Steering Fluid
Honda Coolant
Tools (Some may be affiliate links)
Long Feeler Gauges
Valve Adjustment tool (12mm)
Hondabond
Bolt Biter Sockets
Thread Chaser Set
John Dow Ind Fluid Extractor
Swivel Sockets 1/4” metric
CAT Plug Set
12-14mm zero offset Snap-on
Related Videos
How To Pull Honda Codes Without a Scanner
0:00 Introduction/Overview
0:45 Check Engine Light Codes
3:11 Resetting the Maintenance Light
3:56 Maintenance Start
6:43 Valve Cover Removal
7:06 Spark Plug Removal and Inspection
10:50 Valve Adjustment
19:59 Timing Belt Start
41:38 Water Pump Removal
43:18 Water Pump Install
45:22 Cam Seals
49:33 Cam Gear Installation
50:49 Crank Seal
54:53 Timing Belt Reassembly
58:07 Timing Belt Installation
1:02:39 Setting Timing Belt Tension
1:05:04 Timing Belt Final Assembly
1:06:05 Valve Cover Gasket Installation
1:09:02 PCV Valve Information
1:10:39 Common Oil Leaks
1:12:15 A Pipe Removal
1:15:23 Oil Pan Removal Start
1:17:54 Distributor Removal
1:19:11 Air Tube Removal
1:19:26 Thermostat Replacement
1:24:02 Distributor Service and Tips
1:31:45 Distributor Installation
1:33:21 ATF Drain
1:36:10 Oil Pan Removal Start/Drain Oil
1:37:50 Crush Washer Tip
1:39:28 Thread Chasers
1:40:13 Oil Pan Removal Prep
1:42:49 Oil Pan Removal
1:44:32 Oil Pan Clean/New Gasket
1:48:48 Oil Pan Installation
1:53:32 O2 Sensor Info
1:55:28 Drive Belt Installation
1:57:44 AC Idler Bearing Replacement
1:59:25 AC Belt Installation
2:01:00 Power Steering Belt Installation
2:02:53 IAC Cleaning
2:04:19 Brake Fluid Recommendations
2:05:18 ATF Installation
2:06:49 Adding Oil
2:07:49 Washer Hose Repair
2:10:13 Power Steering Fluid Change
2:12:44 First Start Up
2:17:16 Setting Ignition Timing
2:20:35 Better Throttle Response
2:21:44 Cold Start/Test Drive/Closing
**Answers to your automotive questions found here
Social Network Links
Wanna see more stuff like this from ETCG? Information on Premium Membership
Stay Dirty
ETCG
Due to factors beyond the control of EricTheCarGuy, it cannot guarantee against unauthorized modifications of this information, or improper use of this information. EricTheCarGuy assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. EricTheCarGuy recommends safe practices when working with power tools, automotive lifts, lifting tools, jack stands, electrical equipment, blunt instruments, chemicals, lubricants, or any other tools or equipment seen or implied in this video. Due to factors beyond the control of EricTheCarGuy, no information contained in this video shall create any express or implied warranty or guarantee of any particular result. Any injury, damage or loss that may result from improper use of these tools, equipment, or the information contained in this video is the sole responsibility of the user and not EricTheCarGuy®.
