- This topic has 0 replies, 1 voice, and was last updated 5 years, 1 month ago by .
-
Topic
-
After spending the last 10 days putting in a new clutch hydraulic system and finally getting that going….. started to go for a test drive and the engine is pulsing; revs up and down a little bit. Can sometimes get it to stop briefly after using the gas pedal to really rev it higher but then comes back. Occurs whether or not in gear. Any ideas from anyone?? Didn’t disconnect anything outside of the clutch master/slave cylinder. Can’t tell you rpms as the car tach/gauges/ac have been out for a year or more after a lightning strike at my home; best guess is in revs up and down from idle to around 1500 or so.
thanks
- You must be logged in to reply to this topic.