Menu
  • Home
  • Topic
  • 2006 MDX 3.5L swapped no crank no.start will.stary if starter terminal jumped

2006 MDX 3.5L swapped no crank no.start will.stary if starter terminal jumped

Home Forums Stay Dirty Lounge Service and Repair Questions Answered Here 2006 MDX 3.5L swapped no crank no.start will.stary if starter terminal jumped

This topic contains 1 reply, has 2 voices, and was last updated by Jeff Jeff 4 months ago.

  • Creator
    Topic
  • #987627
    Dustin Wendorf
    Dustin Wendorf
    Participant

    Hello i have choose to do an engine swap ..

    New to MDX 175k motor turned over by hand easy.. new timing belt crank sensor waterpump and thermostat.. all installed … only wont start via the ignition key .. but can jump the starter and she will run loke a champ…

Viewing 1 replies (of 1 total)
  • Author
    Replies
  • #987705
    Jeff
    Jeff
    Participant

    Check the primary circuit to the starter relay with multimeter or listen to it when someone tried to start the vehicle. If you hear the relay click the problem is in the cable to your starter. But most likely it won’t click. I suspect that the problem is in the primary circuit. The most common failure would be the park neutral switch or the safety neutral switch if it’s a manual tranny. Then it could also be the relay itself.

Viewing 1 replies (of 1 total)

You must be logged in to reply to this topic.

Loading…